Acard ACP-2200 Betriebsanleitung PDF herunterladen (Seite 67)

TransTel Model TD-824-I Digital Telephone System – Programming Forms Manual

Page 67

Form 05-12 - System Parameters Form - Miscellaneous

G1-a10h G1-a20u

Form 05-12-T 01 02 03 04 05 06 07 08

Item

Range Of Entries 0 0 0-1 0 - 4 0-1 0 0 0

Default 0 0 0 4 0 0 0 0

05-12-01 – TRF/FL Key Operation:

G1-a20u

If set to 0, transfer procedure requires that the TRF/FL

0=TRF/FL is pressed to transfer a call to a station. When talking to a trunk, will flash the trunk

1=Can transfer to an extension by hanging up. When talking to a trunk, press TRF/FL will flash the trunk.

2=TRF/FL is pressed to transfer a call to a station.

G1-a20u

When talking to a trunk, with a trunk on hold, will create unsupervised conference.

05-12-02 – Mute CO trunk on disconnect (open loop):

g1-a10h (discontinued g1-a10n)

0=Do not Mute 1=Mute Audio on CO on open loop

Note: 05-12-02 was eliminated in software version G1-a10n. It is now an automatic function that is applied

whenever 05-09-03 (CPC loop disconnect) is set to any value other than 0.

05-12-03 - Exclusive Hold:

A call on exclusive hold cannot be readily retrieved by any other station. On all TransTel digital telephone stations,

a call on exclusive hold will appear to other stations as a busy line (steady illuminated red pushbutton). The call

owner will see a slow flash, to differentiate the exclusive call from other calls in the system.

0=Enable 1=Disable

05-12-04 - Door Relay Activation Timer:

This parameter sets the time that the door unlock relay will remain activated after the Door Unlock function is

activated by the user. The Door unlock relay is programmed in Mode 06

0=1 second 1=2 seconds 2=3 seconds 3=4 seconds 4=5 seconds

5=6 seconds 6=7 seconds 7=8 seconds 8=9 seconds 9=10 seconds

05-12-05 - Voice Mail Integration Type:

This parameter selects between Standard Voice Mail Call Forward Protocol and the Digit+ Extension protocol. For

a full description of Voice Mail Protocol see Mode 05-10. This parameter will also enable or disable muting of the

leading digits to the outside caller.

0=Use Form 05-10 DTMF Not Muted 1=Use Digit + Extension spec. DTMF Not Muted

2=Use Form 05-10 DTMF Muted 3= Use Digit + Extension spec. DTMF Muted

4=Same as 0. 5= Use Digit + Extension spec. Not Muted. Does Not

send Direct CO Call Code

6=Same As 2 7= Use Digit + Extension spec. DTMF Muted. Does Not

send Direct CO Call Code.

1 2 ... 62 63 64 65 66 67 68 69 70 71 72 ... 194 195

Keine Kommentare

Acard ACP-2200 Betriebsanleitung Seite 67