Acard PCI-to-IDE ATA-133 Bedienungsanleitung

PCI ATA 133 RAID Controller Card User Manual

Page 10 For Existing Hard Drives with Data 1. As the BIOS boots press F3 when prompted to enter the RAID BIOS. 2. Press F2 to enter the RAID set

Page 11 4. Press Y to use Auto Setup. 5. Press Y to accept the configuration. 6. Configure another RAID set or press ESC to reboot. 7. Continue

Page 12 Rebuilding a Failed Mirror Set If a SPARE drive was not configured, the steps below will guide you in rebuilding a failed mirror set. 1. A

Page 13 14. Answer N to decline Offline Copy. 15. Answer Y to enable Auto-rebuild. 16. When asked Are You Sure?, Press Y to accept. 17. Press ES

Page 14 6. Enter the first destination drive, then enter the second destination drive. 7. Enter Y to accept the RAID configuration. 8. On the fol

Page 15 Rebuilding a Failed RAID 0+1 Set The steps below will guide you in rebuilding a failed Mirror-Stripe set. 1. Replace the failed drive with

Page 16 2. Press F1 to dissolve a RAID set. 3. Enter the number of the RAID set to be deleted. 4. Answer Y to remove the RAID set. 5. Press ESC

Page 17 the “DS-33104\2K_XP_2003_Vista” folder, found on the driver CD, onto a blank floppy disk then follow the directions below. 1. Setup the RAI

Page 18 drive letter), then click OK 4. At the Found New Hardware Wizard, click Next. 5. Select Search for a suitable driver for my device (recom

Page 19 driver. 5. Insert the driver diskette. Press S, then press Enter. 6. Select Silicon Image SiI 0680 ultra-133 Medley ATA Raid Controller a

Page 2 Features and Benefits  Silicon Image SiI 0680  Compliant with UltraDMA6 ATA/133 specifications  Compliant with PCI v2.2 Plug-n-Play 

Page 20 not letter of your CD-ROM drive, substitute D with the correct drive letter), then click OK. 7. The Hardware Installation window pops up,

Page 21 press Next. (Change A:\ to match your floppy drive letter) 6. Follow the on-screen instructions to complete the Windows installation. For

Page 22 Windows® Vista: Double click Storage controllers: -Silicon Image SiI 0680 ultra-133 Medley ATA Raid Controller should be displayed Medley

Page 3 System Requirements  Pentium-class computer with an available PCI slot  Windows® 7, Vista, XP Optional Accessories  Ultra ATA cable H

Page 4

Page 5 Device Connection The UltraATA 133 PCI RAID Card is a dual channel Ultra ATA/133 controller that support up to for IDE hard disk drives. To

Page 6 Note: Only the 40-pin/80-wire UltraATA cable can achieve hard disk UDMA 133 performance. When attaching only two hard drives it is recommen

Page 7 drive, connect it to the end connector of cable. If you have a second hard disk drive, connect it to the middle connector of cable. 4. Recon

Page 8 recommended). 5. Choose the number of hard drives in your stripe set. 6. Assign the hard drives to be used. For optimal performance, altern

Page 9 7. Configure another RAID set or press ESC to reboot. 8. Continue with FDISK and FORMAT steps as if you are installing a conventional hard